Page 1 of 1

Higher timeout value for WU stop/start?

PostPosted: 16.03.2016, 04:01
by boco
Is it possible to configure the timeout value? Already had the first case where 60 seconds are way too low. If the VM/machine is slow or very busy it might take much longer stopping/starting the service. :(

In the specific case the following dynamic determination failed (without error) and nothing got installed.

Re: Higher timeout value for WU stop/start?

PostPosted: 16.03.2016, 10:23
by WSUSUpdateAdmin
Yes, done (doubled).

Thanks,
Torsten